Jump indirect
| Instruction | JMP @A+DPTR |
|---|---|
| Function | Jump indirect |
| Bytes | 1 |
| Cycles | 2 |
| Encoding | 0 1 1 1 0 0 1 1 |
| Operation | PC = A + DPTR |
| Description | JMP @A+DPTR adds the eight-bit unsigned contents of the Accumulator with the 16-bit data pointer and loads the resulting sum to the program counter. This is the address for subsequent instruction fetches. Sixteen-bit addition is performed (modulo 216): a carry-out from the low-order eight bits propagates through the higher-order bits. Neither the Accumulator nor the Data Pointer is altered. No flags are affected |
| Flags Affected | C AC F0 RS1 RS0 OV P |
| Example | An even number from 0 to 6 is in the Accumulator. The following sequence of instructions branches to one of four AJMP instructions in a jump table starting at JMP_TBL. MOV DPTR, # JMP_TBL JMP @A + DPTR JMP_TBL: AJMP LABEL0 AJMP LABEL1 AJMP LABEL2 AJMP LABEL3 If the Accumulator equals 04H when starting this sequence, execution jumps to label LABEL2. Because AJMP is a 2-byte instruction, the jump instructions start at every other address. |
| Bytes: Number of bytes required to encode the instruction. Cycles: Number of instruction cycles required to execute the instruction. Note that there are 12 oscillator cycles to one instruction cycle on a standard 8051. Encoding: Lists the byte encoding for the instruction. Operation: Lists, step-by-step, the operations performed by the instruction. Flags Affected: are highlighted in Bold | |
Related topics:
8051 Program Branching Instructions | 8051 ACALL Instruction | 8051 LCALL Instruction | 8051 RET Instruction | 8051 RETI Instruction | 8051 AJMP Instruction | 8051 LJMP Instruction | 8051 SJMP Instruction | 8051 JZ Instruction | 8051 JNZ Instruction | 8051 CJNE Instruction | 8051 DJNZ Instruction | 8051 NOP Instruction
List of topics: 8051
No comments:
Post a Comment